Hyundai 2013 Genesis User Manual download pdf (Page 325)

What to do in an emergency

166

8. Place the jack at the front or rear

jacking position closest to the tire

you are changing. Place the jack

at the designated locations under

the frame. The jacking positions

are plates welded to the frame

with two tabs and a raised dot to

index with the jack.

9. Insert the jack handle into the jack

and turn it clockwise, raising the

vehicle until the tire just clears the

ground. This measurement is

approximately 30 mm (1.2 in).

Before removing the wheel lug

nuts, make sure the vehicle is sta-

ble and that there is no chance for

movement or slippage.

10. Loosen the wheel nuts and

remove them with your fingers.

Slide the wheel off the studs and

lay it flat so it cannot roll away. To

put the wheel on the hub, pick up

the spare tire, line up the holes

with the studs and slide the

wheel onto them. If this is diffi-

cult, tip the wheel slightly and get

the top hole in the wheel lined up

with the top stud. Then jiggle the

wheel back and forth until the

wheel can be slid over the other

studs.

WARNING - Jack location

To reduce the possibility of

injury, be sure to use only the

jack provided with the vehicle

and in the correct jack position;

never use any other part of the

vehicle for jack support.

OBH068011 OBH068012

1 2 ... 320 321 322 323 324 325 326 327 328 329 330 ... 428 429

Comments to this Manuals

No comments