Hyundai 2012 Santa Fe User Manual download pdf (Page 49)

Safety systems of your vehicle

323

5. Remove as much slack from the belt

as possible by pushing down on the

child restraint system while feeding the

shoulder belt back into the retractor.

6. Push and pull on the child restraint

system to confirm that the seat belt is

holding it firmly in place. If it is not,

release the seat belt and repeat steps

2 through 6.

7. Double check that the retractor is in

the “Automatic Locking” mode by

attempting to pull more of the seat belt

out of the retractor. If you cannot, the

retractor is in the “Automatic Locking”

mode.

To remove the child restraint, press the

release button on the buckle and then

pull the lap/shoulder belt out of the

restraint and allow the seat belt to retract

fully.

When the seat belt is allowed to

retract to its fully stowed position, the

retractor will automatically switch

from the “Automatic Locking”mode to

the emergency locking mode for nor-

mal adult usage.

C030103AFD

Securing a child restraint seat with

“Tether Anchor” system

(if equipped)

Child restraint hook holders are located

on the back of the rear seats.

WARNING - Automatic

Locking mode

The lap/shoulder belt automatically

returns to the “emergency locking

mode”whenever the belt is allowed

to retract fully. Therefore, the pre-

ceding seven steps must be fol-

lowed each time a child restraint is

installed.

If the retractor is not in the

Automatic Locking mode, the child

restraint can move when your vehi-

cle turns or stops suddenly. A child

can be seriously injured or killed if

the child restraint is not properly

anchored to the car, including set-

ting the retractor to the Automatic

Locking mode.

OCM030033

OEN036104

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 418 419

Comments to this Manuals

No comments