Hyundai 2012 Santa Fe User Manual download pdf (Page 321)

619

What to do in an emergency

Then position the wrench as shown

in the drawing and tighten the wheel

nuts. Be sure the socket is seated

completely over the nut.Do not stand

on the wrench handle or use an

extension pipe over the wrench han-

dle.

Go around the wheel tightening

every other nut until they are all tight.

Then double-check each nut for

tightness. After changing wheels,

have an authorized HYUNDAI dealer

tighten the wheel nuts to their proper

torque as soon as possible.

Wheel nut tightening torque:

Steel wheel & aluminium alloy wheel:

65~79 lb.ft (9~11 kg.m)

If you have a tire gauge, remove the

valve cap and check the air pressure.

If the pressure is lower than recom-

mended, drive slowly to the nearest

service station and inflate to the cor-

rect pressure. If it is too high, adjust

it until it is correct. Always reinstall

the valve cap after checking or

adjusting tire pressure. If the cap is

not replaced, air may leak from the

tire. If you lose a valve cap, buy

another and install it as soon as pos-

sible.

After you have changed wheels,

always secure the flat tire in its place

and return the jack and tools to their

proper storage locations.

CAUTION

Your vehicle has metric threads

on the wheel studs and nuts.

Make certain during wheel

removal that the same nuts that

were removed are reinstalled -

or, if replaced, that nuts with

metric threads and the same

chamfer configuration are used.

Installation of a non-metric

thread nut on a metric stud or

vice-versa will not secure the

wheel to the hub properly and

will damage the stud so that it

must be replaced.

Note that most lug nuts do not

have metric threads. Be sure to

use extreme care in checking

for thread style before installing

aftermarket lug nuts or wheels.

If in doubt, consult an author-

ized HYUNDAI dealer.

OXM069007

1 2 ... 316 317 318 319 320 321 322 323 324 325 326 ... 418 419

Comments to this Manuals

No comments