Hyundai 2009 Sonata User Manual download pdf (Page 95)

1

FEATURES OF YOUR HYUNDAI

82

!

handheld transmitter every two seconds

until the frequency signal has been learned.

The indicator light will flash slowly and

then rapidly after several seconds upon

successful training.

Operating HomeLink

®

To operate, simply press and release the

programmed HomeLink

®

button. Activation

will now occur for the trained device (i.e.

garage door opener, gate operator, security

system, entry door lock, home/office

lighting, etc.). For convenience, the hand-

held transmitter of the device may also be

used at any time.

Reprogramming a Single HomeLink

®

But-

ton

To program a new device to a previously

trained HomeLink

®

button, follow these

steps:

1. Press and hold the desired HomeLink

®

button. Do NOT release until step 4 has

been completed.

2. When the indicator light begins to flash

slowly (after 20 seconds), position the

handheld transmitter 1 to 3 inches away

from the HomeLink

®

surface.

3. Press and hold the handheld transmitter

button. The HomeLink

®

indicator light

will flash, first slowly and then rapidly.

4. When the indicator light begins to flash

rapidly, release both buttons.

5. Press and hold the just-trained

HomeLink

®

button and observe the red

Status Indicator LED. If the indicator

light stays on constantly, programming

is complete and your new device should

activate.

Erasing HomeLink

®

Buttons

Individual buttons cannot be erased.

However, to erase all three programmed

buttons:

1. Press and hold the two outer HomeLink

®

buttons until the indicator light begins to

flash-after 20 seconds.

2. Release both buttons. Do not hold for

longer than 30 seconds.

The Integrated HomeLink

®

Wireless

Control System is now in the training (learn)

mode and can be programmed at any time

following the appropriate steps in the

Programming sections above.

FCC ID: NZLZTVHL3

IC: 4112A-ZTVHL3

This device complies with Part 15 FCC

Rules. Operation is subject to the following

two conditions: (1) this device may not

cause harmful interference, and (2) this

device must accept any interference

received, including interference that may

cause undesired operation.

WARNING:

The transceiver has been tested and

complies with FCC and Industry Canada

rules. Changes or modifications not

expressly approved by the party

responsible for compliance could void

the user's authority to operate the

device.

NVS

®

is a registered trademark and Z-

Nav™ is a trademark of the Gentex

Corporation, Zeeland, Michigan.

HomeLink

®

is a registered trademark

owned by Johnson Controls, Incorporated,

Milwaukee, Wisconsin.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 285 286

Comments to this Manuals

No comments