H-CMDN60002 DIN DVD/CD/MP3 RECEIVER WITH BUILT-IN 6.5” TFT DISPLAYInstruction manual DVD/CD/MP3- 2 DIN 6.5” TFT-
10Briefly press it to activate the traffic alarm function; press and hold it to select the bands.10. REL/NAV buttonPress it to slide down the front pa
100, , .
101 ..
102. ..
103DVD/CD/MP3 12 50 4 DVD/DVD±R
104GPS 25 ° -149 «» <60 () «» <35
11Remote control1. AF/EQ button2. SOURCE button3. GOTO button4. BND/TITLE button5. AMS/MENU button6. LOC/SUB-T button7. ST/AUDIO button8. OSD
1222. PAUSE button23. STOP button24. RPT button25. RDM button26. SEL buttonChanging the battery1. Press the catch and at the same time pull ou
13General operationsReset the UnitOperating the unit for the first time or after replacing the car battery, you must reset the unit. Remove the frontp
14Volume ControlPress VOL+/VOL- button on the RC or on the unit to increase/decrease the sound level.Turning Loudness On/OffPress and hold TA/LOUD but
15Insert an SD CardPress REL button after turning the unit on, then insert an SD card into SD slot when the TFT is slanted, and thecontents of the car
16Main menuNote: This unit can be operated by touching the screen buttons. Thus youcan select the menus and change the parameters.When the unit is on,
17Press and buttons to adjust the desired FAD level, press EXIT toexit this menu.Note: When adjusting the other options perform the same ope
18System AdjustIn this menu you can adjust CLOCK SYS (clock system), KEY BEEP,MONI FLEX (monitor flex), REVER POLA (reverse polarity),SUBWOOFER, AMS F
19Note: This function is not available.AMS FullupIn this menu you can set the modes of AMS. When the setup is ON, the presettable stations are full, n
2Dear customer!Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefullybefore connecting, operating
20Adj ScreenPress ADJ SCREEN to display the above menu, there are a square button at the top left corner and a tip: pleasepress the button. Press the
21Digital tuner operationsMode selectingPress the SRC/PWR button on the unit or SOURCE button on the RC repeatedly to switch to RADIO mode.User interf
22Band selectionPress the BND/TITLE button on the RC or on the touch screen to switch to the bands in the following order:FM1 - FM2 - FM3 - AM1 - AM2
23Scanning/Memorizing Stations AutomaticallyDuring radio mode, you can press AMS/MENU button on the RC or AMS button on the monitor to scan eachstored
24RDS Setup1. AF. Press it to activate AF function.2. . Press it to activate TA function.3. /. Press it to select PTY code.4. PTY. Press it to act
25Program TypeBriefly press PTY/ANGLE button on the RC or PTY button on the monitor to activate PTY function.When PTY is on, PTY ON appears on the mon
26Disc operationsDiscs for playback This unit can play disc types: DVD/DVD±R/DVD±RW/CD/CD-R/CD-RW. Compatible with formats: DVD/SVCD/VCD/MP3/WMA/H
27DVD operationsGlossaryPBC (Play Back Control)Play Back Control is a menu recorded on the disc with SVCD or VCD2.0 format. For the discs contained PB
28Playing a DVDInsert a DVD disc into the disc slot, the unit will automatically switch on, if a DVD disc is loaded, pressENTER button to start the pl
29Repeat PlayingPress RPT button on the RC to perform replaying function as followings:System SwitchDuring playback mode, Press P/N button on the RC t
3GPS operations...
30Changing the viewing angle (Multi-angle)With DVDs featuring multi-angle (scenes shot from multiple angles) recordings, you can press PTY/ANGLEbutton
31DVD Setup menu1. Press SETUP button on the RC to enter the setup menu.2. Use the / buttons to choose the setup page: General page, Dolby Digital
32If the Screen saver is set On and the unit is switched on without a disc playing for 3 minutes, a moving pictureappears on the TFT.Dolby digital set
33 AUDIO, SUBTITLE, DISC MENUSet the desired languages for all the settings. If a setting is supported by disc content, it will work. Otherwisethe d
34Reset to the initial factory setups.ExitSelect the Exit page to exit the Setup menu.
35VCD/CD operationsAlong with buttons of the RC and the unit you can use touch buttons of thismenu to perform some of the following operations.Playing
36Number ButtonsPress one of number buttons (0-9) to play a track you want.Stop PlaybackPress STOP button, then press ENTER or PAUSE button on the RC
37On Screen DisplayBriefly press OSD button and the display will show:Single elapsed => Single remain => Total elapsed => Total remain =>
38Program PlayingDuring VCD/CD mode, press PROG button, the monitor displays the program menu. Press number buttons toselect the track number and then
39MP4 Disc operationsPlaying tracksInsert an MP4 (AVI, MPEG4) disc into the disc slot, the unit will automatically switch on, if a disc is loaded,pres
4Important safeguards Using the device at temperature below -10º may cause the breakage of the device.Before using, please, heat up the passenger c
40On Screen DisplayBriefly press OSD button the display shows:Press and hold OSD button on the RC to display the current setup.Setting the Playback Ti
41MP3/SD operationsAlong with buttons of the RC and the unit you can use touch buttons of thismenu to perform some of the following operations.Playing
42Selecting the MP3/SD TrackPress GOTO button and the monitor will show: ---. Then press Number Buttons to enter the Mp3 track numberand press then EN
43MP3 overview MP3 is short for MPEG Audio Layer 3 and refers to an audio compression technology standard. This product allows playback of MP3 fil
44AUX/TV operations (optional)Press SRC button to switch to AUX mode.Along with buttons of the RC and the unit you can use touchbuttons of this menu t
45You can adjust the following items:SOUND: M/N, B/G, D/K.BAND: V-l, V-H, UHFMODE: SECAM/NTSC/PAL7. Mode selector8. Preset stations. To show all of
46GPS operationsPress and hold the REL/NAV button on the unit to activate the GPS function.For details of operating the in-built GPS navigation system
47Handling and cleaning discs Dirty, scratched or warped discs may cause skip ping or noise. Handle the disc only by the edges. To keep clean do n
48Troubleshooting guideSymptomCause SolutionNo power.The car ignition is not on.The fuse is blown.If the power supply is properlyconnected to the car
49SpecificationDVD/CD/MP3 RECEIVERGeneralPower supply: 12 V DCMaximum power output: 50 W x 4 channelsCompatible disk types: DVD/DVD±R/DVD±RW/CD/CD-R/
5Accessories
50GPSTEMP 25 °Satellite Acquisition Sensitivity -149dBmCold Start Time <60S (Open sky)Warm Start Time <35S (Open sky)Hot Start <10S (Open sk
51! .
52...
53 -10º.
541. 1 . 2. 1 . 3. 4. 5 - 4 . 1 .
55 1: 2:.
56..
571. 2. 3. :
581. SRC/PWR .
59. SD ., GPS.11.
6Installation/connectionInstallation method 1: DIN Front-mountInstallation method 2:Installation using the screw holes at the sides of the unit.Select
60 ()1. AF/EQ2. SOURCE3. GOTO4. BND/TITLE5. AMS/MENU6. LOC/SUB-T7.
6122. PAUSE23. STOP24. RPT25. RDM26. SEL
621. , .2. (CR 2025 3V),
63, .
64OFF. – OFF. VOL+/VOL-
65SD REL , , , SD ,
66: .
67, FAD . ,
684. SYSTEM () CLOCK SYS, KEYBEEP, MONI FLEX, REVER POLA, SUBWOOFER, AMS FULLUP,LOCAL AREA
69REVER POLA (). +12 V,
7Detach the unitDetach the front panel before disassembling the unit.Take out the Outer trim frame.
70 ON (), GOTO .RT Scroll (
71 SRC/PWR SOURCE .
7210. 6 . , ; , 6 .11.
73 MO/ST ST/AUDIO .
74 RDS1. AF – AF.2. – TA.3. / – PTY.4. PTY –
75 «TA» ; . TA
76 :DVD/DVD±R/DVD±RW/CD/CD-R/CD-
77 DVD, PBC () – ,
78 DVD DVD , . DVD ENTER
79 (0-9) ; .
8Electrical Connection1. Output plug2. Output socket3. Tuner receptionNote: The brown wire is connected with brake signal; for safety, the programs ca
80 OSD : => =>
81: , multi-audio. ( Multi-subtitle) DVD
82 DVD1. SETUP , .2. / :
83, DVD , , .
84 .PAL: , ,
85 , . ,
86 VCD/CD .
87 (0-9) . STOP.
88 . :
89 ENTER . /.
9Unit controlsFront panel1. SRC/PWR buttonDuring waiting mode, briefly press it to turn onthe unit; during working status, briefly press itto select
90 ENTER. STOP PROG
91 MP4 MP4 (AVI, MPEG4) ; .
92 OSD : –
933 .
94 STOP, . MP3 GOTO;
95 MP3 3 MPEG 3 .
96 AUX/ () SRC AUX.
97:SOUND (): M/N, B/G, D/K.BAND (): V-l, V-H, UHFMODE (): SECAM/NTSC/PAL7.
98 GPS REL/NAV , GPS.
99 , .
Comments to this Manuals